-
WEBSITE
How to set up a separate guest network for wifi for solar provider ...
February 2022. What you would do is plug the new router directly into the modem and eliminate the Spectrum router. It is not required that you use our router. Once you get your new router, you would want to take the Spectrum router back to a Spectrum store so that the router can be removed from the account and the monthly charge can be removed ...
Do more...
Share, comment, bookmark or report
-
WEBSITE
iPhone devices not connecting to guest network
manual workarounds to get iPhone connected to the guest network work but this is not a scalable fix. ( manual solutions include, changing dns settings to manual -> add dns servers. Turn WiFi OFF and Turn ON Again. Go to iOS settings, then WiFi and turn WiFi OFF. Go to iOS settings, then Cellular and turn Cellular Data OFF.
Do more...
Share, comment, bookmark or report
-
WEBSITE
Configuring guest access on 2504 WLC - Cisco Community
allow internet on that vlan's ip subnet. configure a dynamic interface using that vlan in the WLC. configure new ssid in controller ...GUEST. map the dynamin interface guest. if you want preshared key security for your guest than configure any PSK key under WLAN--GUEST--layer2 security and hit apply.
Do more...
Share, comment, bookmark or report
-
WEBSITE
Guest WiFi + Network separation - Cisco Community
Guest WiFi + Network separation. RS19. Level 4. Options. 05-17-2020 06:44 PM - edited 07-05-2021 12:03 PM. I am planning to implement guest WiFi access in my network. Already we have the Cisco AP & WLC in place. The existing Cisco AP has 1 SSID for intra WiFi access. The WLC is in the Data center & the APs are in branch locations.
Do more...
Share, comment, bookmark or report
-
WEBSITE
Solved: Guest access on the 5508 WLC - Cisco Community
Hi, I'm looking to implement guest WiFi access with web authentication on one of our 5508 WLC (currently deployed within a sandbox environment), but looking for some assistance. The WLC currently has a single connection from port 1 to the 'Test Site 2' switch. This is a dot1q trunk. On the WLC, the interface (for port 1) is configured as follows:
Do more...
Share, comment, bookmark or report
-
WEBSITE
Solved:"No internet access" on Guest Wifi - Cisco Community
We have a server doing the DHCP (10.27.131.8) for both the secure (10.27.131.0 network) and for the Guest (10.26.131.0 network). The Secure wifi is working as it should be - the Guest however is not. Visitors can connect and get a valid IP address from the 10.26.131.0 network but have no internet access. Everything else has stayed the same - no ...
Do more...
Share, comment, bookmark or report
-
WEBSITE
ISE Guest Access Prescriptive Deployment Guide
Enable both the Wi-Fi Redirect to Guest Login and the Wi-Fi Guest Access policies. Click Save. Under Policy Sets, you can edit the existing rule for Wi-Fi_Guest_Access policy. Click the pencil icon. Make the changes, as shown in the figures below, and then click Save. When you complete this procedure, your policy will look like this.
Do more...
Share, comment, bookmark or report
-
WEBSITE
Solved: Guest Wireless and DNS - Cisco Community
Guest Wireless and DNS. 01-24-2012 06:49 PM - edited 07-03-2021 09:26 PM. During our implementation of Guest Wireless (currently ongoing), we are trying to decide where to point to for DNS. We have a 5508 WLC in our Internet DMZ and it acts as the Anchor WLC. This WLC is also used as the DHCP server for the Guest Wireless clients.
Do more...
Share, comment, bookmark or report
Comments